Integrating MoreLogin with XProxy
Ask AI
Ready taskDo it with me, step by step
Chat assistants
Open in ChatGPTNew tabOpen in ClaudeNew tabCoding agents
Claude CodeOpens the desktop appCodexOpens the desktop appCursorOpens the app from the webCopy
View as MarkdownPlain text for AI toolsSee the prompt
Read https://xproxy.io/document/integrating-morelogin-with-xproxy.md, the XProxy guide "Integrating MoreLogin with XProxy". If you cannot open links, download them with curl. Then take me through it one step at a time: tell me exactly what to click or type, wait until I say it is done, and help me when what I see is different from the guide. Start by asking what I have (hardware, XProxy version, what I see now). Other XProxy guides, each with a Markdown copy at its URL + .md, are listed in https://xproxy.io/llms.txt.
The app opens with the prompt filled in. Nothing runs until you press Enter.
Use an XProxy mobile proxy in MoreLogin. Copy it from your panel, paste it into MoreLogin and check it. It takes about 5 minutes.
You need: an XProxy panel with a working modem, and MoreLogin on your computer. MoreLogin can run on another computer than XProxy: choose Public address or VPS relay when you export.
Step 1 of 6
Open Export Proxy in your XProxy panel
Open your XProxy panel in a browser and click Proxy Management in the left menu.
Click Export Proxy 1.
Can't open the panel? See how to open your dashboard.
Something not working?
| You see | What to do |
|---|---|
| MoreLogin says the proxy does not work, or times out | Check that your computer can reach the address in the line. A LAN only address works only on your own network: export again with Public address or VPS relay (public access). Also check that the port is the one shown in Proxy Management. |
| Login failed, or "407 Proxy Authentication Required" | Copy the proxy again after saving Proxy Settings → Login, and check for spaces before or after the text. Using Whitelist IP instead of a password? Add the public IP of the computer that runs the app. |
| The proxy connects right after you paste it, then fails | The type in the app must match what you exported. The GoLogin / AdsPower preset is HTTP, the Multilogin / VMLogin preset is SOCKS5. Or export again with the other Protocol. |
| The test page shows your own IP | The profile is not using the proxy. Open its proxy settings, make sure the proxy is selected, and set WebRTC to Replace or Disabled. Test again at the XProxy leak test. |
| The rotation link does nothing, or the IP stays the same | The modem needs a few seconds to reconnect, so wait about 10 seconds. Sometimes the carrier gives back the same IP: rotate again. Paste the link in a browser tab: it should answer command_sent. Profiles that share one proxy share its IP too, so rotating changes it for all of them. |
| Rotating changes the IP of other profiles too | Profiles that share one proxy and one Refresh URL share the IP. Give each profile its own proxy if it needs its own IP. |
Still stuck?A technician can look at your device with a one-time PIN, or chat with us on Telegram.

